To Make 2 Sensor Sets

1. After the first set has been made, turn off your sensors and turn on your second set of sensors.
2. With the CABLE on, connected to the CABLE Util app and your sensors activated, go to the menu in the CABLE Util app and select "Switch To Set: Sensor Set 2."
3. Tap for the menu to "Scan ANT+ Sensors" and continue to setup your sensors like the previous set.
4. To know what set you are using, your sensor set name is located at the top left side of the CABLE Util app. 

NOTE: You must change your sensor set in the CABLE Util app each time you change sets. CABLE itself does not recognize the set you are using unless changed in the CABLE Util app. 

Rename Sensor Set: Set 1/2

1. With your CABLE turned on and connected to the CABLE Util app, go to the menu and select "Rename Sensor Set: Sensor Set 1/2."
2. A pop-up will enable you to update the name of your sensor set. 

Switch to Set: Set 1/2

1. With your CABLE turned on and connected to the CABLE Util app, go to the menu and select "Switch To Set: Sensor Set 1/2."

NOTE: You will need to go into the CABLE Util app to switch your sets each time you workout if you are using a different sensor setup.